winchester sx3 besitzer hier?

Registriert
30 Nov 2011
Beiträge
576
Heißes Wasser und Spülbürste...
Trocknen lassen, leicht einölen und einbauen. Wenn es nicht zu arg verschmutzt ist, reicht etwas WD40 und ein Spülschwamm.

WaiHei
 
Registriert
30 Nov 2011
Beiträge
576
Der letzte Rest muss auch nicht unbedingt raus. Verfahre wie oben beschrieben, seit Jahren mit meiner Maxus ( fast baugleich ) so.
Alternativ könntest Du auch Bremsenreiniger einsetzten.

WaiHei
 
G

Gelöschtes Mitglied 21155

Guest
Man tut seinen Waffen prinzipiell etwas Gutes wenn man sich an die Bedienungsanleitung hält, bzw sie liest. Der Hersteller kennt die Waffe wie niemand sonst.

Cleaning the Gas System
1. Remove the gas piston, piston sleeve spring and pistonsleeve from the magazine tube as explained in“Disassembly” on page 14.

2. Spray the magazine tube, gas piston and piston sleevewith gun solvent and brush them thoroughly with anylon brush to remove any deposits. It will be easier toremove the piston sleeve spring to clean the interiorof the piston sleeve. Spray the inside of the gas pistonwith solvent. A green Scotch-Brite® kitchen scrub padworks best for removal of heavy carbon fouling on thetube and inside the gas piston. Do not remove thespring inside of the piston. Never use a steel brush onany of the gas system components.

3. Complete the cleaning of the gas system by applyinga very light film of oil to all parts for protectionand lubrication.
 
G

Gelöschtes Mitglied 21155

Guest
Das liest Du falsch. Bitte nichts zerlegen. Lediglich die große, ich nenne sie mal Feder der Kolbenhülse (die man ja eh leicht heraus ziehen kann) soll/kann entfernt werden.

Es steht geschrieben: Do not remove thespring inside of the piston


 
Zuletzt bearbeitet von einem Moderator:
Registriert
17 Nov 2016
Beiträge
1.274
Man tut seinen Waffen prinzipiell etwas Gutes wenn man sich an die Bedienungsanleitung hält, bzw sie liest. Der Hersteller kennt die Waffe wie niemand sonst.

Cleaning the Gas System
1. Remove the gas piston, piston sleeve spring and pistonsleeve from the magazine tube as explained in“Disassembly” on page 14.

2. Spray the magazine tube, gas piston and piston sleevewith gun solvent and brush them thoroughly with anylon brush to remove any deposits. It will be easier toremove the piston sleeve spring to clean the interiorof the piston sleeve. Spray the inside of the gas pistonwith solvent. A green Scotch-Brite® kitchen scrub padworks best for removal of heavy carbon fouling on thetube and inside the gas piston. Do not remove thespring inside of the piston. Never use a steel brush onany of the gas system components.

3. Complete the cleaning of the gas system by applyinga very light film of oil to all parts for protectionand lubrication.
davon steht bei mir nichts.die anleitung ist ganze 3 seiten lang.
 

Online-Statistiken

Zurzeit aktive Mitglieder
77
Zurzeit aktive Gäste
547
Besucher gesamt
624
Oben